Adafruit

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use ...

The SmartiPi Touch 2 is a Pi 4 compatible case that is perfect for use with the official 7" Touchscreen Display.  It offers various front-pieces fo...

Looking for another way to keep your Raspberry Pi cool? Hook up this 5V Mini Cooling Fan and prevent your hard-working Pi from overheating! Of cour...

Get that heat sink stuck on good and strong with 3M's thermal tape. Specifically designed for attaching heat sinks to ICs. Works better and is less...

The Raspberry Pi has an on-board audio jack, which is super handy for all kinds of sound effects and speech, just plug and go! However, for when yo...

This is a basic, classic Pi Zero enclosure with a black base and a clear top. The case is as minimal as it gets, coming in just two pieces of polyc...

This is a nice half size breadboard, good for small projects. It's 2.2" x 3.4" (5.5 cm x 8.5 cm) with a standard double-strip in the middle and two...

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size....

This is a basic, classic Adafruit Raspberry Pi Camera Board Enclosure with a black base and a clear top. The case is as minimal as it gets, coming ...

Looking for a nice way to cool down your Raspberry Pi? Check out this 14x14x8 Heat Sink! This heat sink is made from high quality aluminum and will...

This is the only Motor Controller for Arduino that you will ever need to buy!  The Adafruit Motor/Stepper/Servo Shield is simply one of the best sh...

Connect your own PCB to a Raspberry Pi B+ and stack on top with this normal-height female header with extra long pins.  The female header part is ...

If you've ever been curious about software defined radio (SDR), this USB stick is the easiest way possible to have fun with a powerful, configura...

PowerBoost 1000C is the perfect power supply for your portable project! With a built-in load-sharing battery charger circuit, you'll be able to ke...

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use...

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use ...

This 4-button keyfob remote goes with Adafruit's three basic 315MHz RF receiver modules. It will work with all of them, sending out one of four com...

These nice switches are perfect for use with breadboard and perfboard projects. They have 0.1" spacing and snap in nicely into a solderless breadbo...

This 3" diameter speaker cone is the perfect addition to any audio project where you need an 4 ohm impedance and 3W or less of power. We particula...

We carry a few different GPS modules here in the shop, but none that satisfied our every desire - that's why Adafruit designed this little GPS brea...

Connect your own PCB to a Raspberry Pi B+ with this normal-height female header. The female header part is about 8.5mm tall, good for small HATs th...

This Raspberry Pi add-on is perfect for any motion project as it can drive up to 4 DC or 2 Stepper motors with full PWM speed control.  This is th...

Looking for an ultra-thin heat sink for your Raspberry Pi? Check out this nice and slim 13x13x3mm Heat Sink! This heat sink is made from high quali...

These Simple RF receivers are the easiest way possible to add wireless control, painlessly! There's no programming, configuring or addressing - sim...