Products

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better known...

For winding custom coils, or very fine-pitch rework, we always reach for magnet wire. Magnet wire is very very thin (0.1mm diameter!) copper wire w...

Give your Ultimate GPS V3 a boost with this external active antenna. This GPS antenna draws about 10mA and will give you an additional 28 dB of gai...

This is a nice half size breadboard, good for small projects. It's 2.2" x 3.4" (5.5 cm x 8.5 cm) with a standard double-strip in the middle and two...

This silicone mat is made of 4mm thick rubber and can take just about anything you throw at it. It's stable, strong, non-slip, non-conductive and h...

If this keyboard doesn't catch your eye, we don't know what will! It's cool, it's colorful, and it's clicky in the best way, and it'll make you fee...

Add another 8 pins to your microcontroller using a MCP23008 port expander. The MCP23008 uses two i2c pins (these can be shared with other i2c devic...

Sometimes a simple analog control device can be the perfect tactile solution for your project, but they can be surprisingly hard to come by. Luckil...

This Mini Power Meter with Voltage, Current, Watts, mAh & mWh Display (whew that is a mouth-full) is a lot like the USB In-Line Voltage and Cur...

Unleash your inner Mad Max and make your vehicle dreams a reality with the Mini Robot Rover Kit. This kit gives you everything you need to build th...

This Panel Mount 10K Dual Log Potentiometer is a dual-ganged potentiometer that will satisfy all your stereo-signal needs. Instead of just one pote...

This Panel Mount 10K Dual Logarithmic Potentiometer w/ On-Off Switch is a two-in-one; you get a dual-ganged potentiometer and an on-off switch. For...

This potentiometer is a two-in-one, good in a breadboard or with a panel. It's a log taper 10K ohm potentiometer, with a grippy shaft. It's smooth ...

This Panel Mount Right Angle 10K Linear Potentiometer w/ On-Off Switch is a two-in-one, with both a breadboard-friendly potentiometer and a switch....

Transistors are powerful little electronic switches, and we really like these PNP transistors whenever we need to control medium-power electronics,...

PowerBoost is the perfect power supply for your portable project! This little DC/DC boost converter module can run from 1.8V batteries or higher, a...

NOOBS (New Out Of the Box Software) is an easy operating system installer which contains Raspbian and LibreELEC. It also provides a selection of a...

This new Adafruit shield makes it easy to use a 16x2 Character LCD. We really like the RGB LCDs we stock in the shop both the RGB negative and RGB ...

If you've ever been curious about software defined radio (SDR), this USB stick is the easiest way possible to have fun with a powerful, configura...

Take your gardening project to the next level with a SHT-10 based soil sensor. The sensor includes a temperature/humidity sensor module from Sensir...

They're yellow, they're square, they live in a pineapple under the sea... okay maybe not that last part, but this pack of three (3!) solder station...

Is there something missing from your tool kit or workstation? Are you having trouble figuring out which elusive tool it is that you're lacking? Per...

Get your bearings with the LSM303 Triple Axis Accelerometer / Compass board!  Inside are two sensors, one is a classic 3-axis accelerometer, which ...