Products

This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SPI t...

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that...

Also available in green! What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an 8x8 matrix or a 4-digit 7-se...

The Adafruit Pi Plate makes it easy to use a blue and white 16x2 Character LCD. Some 16x2 LCDs do require quite a few digital pins, 6 to control t...

Add powerful and easy-to-use Bluetooth Low Energy to your robot, art or other electronics project? With BLE now included in modern smart phones an...

Feather is the new development board from Adafruit, and like it's namesake it is thin, light, and lets you fly! We designed Feather to be a new st...

LEDs and passives and transistors and switches oh my! The Adafruit Parts Pal is the ultimate companion for an entry-level maker learning electroni...

Design your own Pi HAT, attach custom circuitry and otherwise dress your Pi A+, B+, or Pi 2 with this jaunty prototyping HAT kit with EEPROM To ki...

his prototyping shield is the best out there (well, we think so, at least), and now is even better with Version R3 - updated for the most compatibi...

This new Adafruit Pi Plate makes it easy to use an RGB 16x2 Character LCD. We really like the RGB Character LCDs we stock in the shop. (For RGB w...

This new Adafruit Pi Plate makes it easy to use an RGB 16x2 Character LCD. We really like the RGB Character LCDs we stock in the shop. (For RGB we ...

Connect this to that without soldering using these handy mini alligator clip test leads. 5" overall cables with alligator clip on each end, color c...

We put a PermaProto quarter-sized proto board in a blender with a Pi Cobbler and out emerged this very tasty confection - the PermaProto for Pi! It...

We carry a few different GPS modules here in the shop, but none that satisfied our every desire - that's why Adafruit designed this little GPS brea...

This kit is for making your own breadboard-friendly very low dropout adjustable power supply. A good power supply is essential to electronic proje...

What's better than a single LED? Lots of LEDs! A fun way to make a small linear display is to use two 12-bar Bi-color bar-graphs. Wouldn't it be aw...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better known...

A Feather board without ambition is a Feather board without FeatherWings! This is the FeatherWing Proto - a prototyping add-on for all Feather boar...

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are a little over 12" (300mm) long and come in a ...

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are a little over 6" (150mm) long and come in a '...

FLORA is Adafruit's fully-featured wearable electronics platform. It's a round, sewable, Arduino-compatible microcontroller designed to empower am...