Products

This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SPI t...

Bring out the Raspberry Pi pins for your project using this male to female extender. Available in various lengths. Comes complete with lovely rainb...

The easiest way to prototype using your Raspberry Pi.  The paddle board features individually sprung terminals to insert jumper cables or cable co...

The easiest way to prototype using your Raspberry Pi.  The Raspberry Split fits perfectly on to your breadboard allowing you to use your jumper ca...

Also available in green! What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an 8x8 matrix or a 4-digit 7-se...

LEDs and passives and transistors and switches oh my! The Adafruit Parts Pal is the ultimate companion for an entry-level maker learning electroni...

We carry a few different GPS modules here in the shop, but none that satisfied our every desire - that's why Adafruit designed this little GPS brea...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better known...

Give your Ultimate GPS V3 a boost with this external active antenna. This GPS antenna draws about 10mA and will give you an additional 28 dB of gai...

This is a nice half size breadboard, good for small projects. It's 2.2" x 3.4" (5.5 cm x 8.5 cm) with a standard double-strip in the middle and two...

OK you've signed up for Adafruit.io and you're ready to build something cool and Internet-connected. All you need is this starter kit which will g...

MonkMakes Protoboard is designed to make the creation of one-off projects and prototypes as simple to make as possible by: Using the same layout ...

Protect all your GPIO pins with this board. It sits comfortably in-between your Raspberry Pi and your project to provide protection from accidenta...

The Raspberry Pi Sense HAT is attached on top of the Raspberry Pi via the 40 GPIO pins. The Sense HAT has several integrated circuit based sensors...

These Simple RF receivers are the easiest way possible to add wireless control, painlessly! There's no programming, configuring or addressing - sim...

The Solar Science Station is a non-soldering solar USB charger. Use it as a tool for recording solar data in the classroom and as a power supply f...

Get your bearings with the LSM303 Triple Axis Accelerometer / Compass board!  Inside are two sensors, one is a classic 3-axis accelerometer, which ...

Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are ...