Products

With this Bulldozer add-on for :MOVE mini for the BBC microbit, everyone's favorite little programmable robot buggy just got much better. Robots of...

Hey want to hear a really loud noise? Apply 3V to 5V to this buzzer module and you'll be rewarded with a loud 2KHz BEEEEEEEEEEEEEEEEEP. Unlike a pl...

We have some great waterproof and weather-proof items in the shop, but once you have a project built, you'll want to enclose it. But how to keep an...

We have some great waterproof and weather-proof items in the adafruit shop, but once you have a project built, you'll want to enclose it. But how t...

Whaddya got a screw loose or something? This 3/8" to 1/4" Adapter Screw is super handy if you're building projects that connect to a tripod or a ca...

Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakout board, starring the...

This black  HiFiBerry Steel Case is a beautiful and robust two-part steel case for the HiFiBerry RCA. This model is for Black both RCA and ADC.  P...

The CASEplate is a highly recommended mounting system for your Pi-Plates stack. It includes everything you need to securely hold and protect your ...

These earbud headphones are the perfect accessory for your FONA - they've been tested to work with our modules - but can be used with any iOS or An...

Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playgro...

It's the Circuit Playground Express Base Kit! It provides the few things you'll need to get started with the new Circuit Playground Express. This v...

This is a 2xAAA battery box for the micro:bit.  It has a JST-PH connector and an on off switch.  This way you can leave your battery pack plugged i...

Our new clippable servo has had the standard pin header replaced with super useful crocodile clips. This allows it to be used in projects that feat...

This is 12 meters of smooth conductive thread spun from stainless steel fiber and wound on a plastic bobbin. Use it to sew up all of your e-textile...

The MonkMakes Connector for micro:bit makes it super-easy to connect I2C, SPI and other devices to your micro:bit without losing the main connecto...

These LED strips are ultra bright, fun and glowy. There are 60 cool white LEDs per meter, and you can control the entire strip at once with any mic...

These are the highest quality & capacity batteries, the same as shipped with the iCufflinks, iNecklace, Datalogging and GPS Shields, GPS HAT, e...

A perfect match for our sew-able coin cell holder. This non-rechargeable coin cell is CR2032 sized: 20mm diameter, 3.2mm thick. It has a nominal vo...

Create your own electronics projects in minutes with the Crazy Circuits Starter Set. Design your own projects from scratch or follow one of our ma...

You have some frickin' sharks at your lair, and you're thinking "it would be really great if I could attach some lasers to them" and then you see t...

The Cyntech Raspberry Pi Case has been redesigned for the Pi 4.  Also available for the Raspberry Pi 3 and earlier. The lid has been given a make o...

Cyntech's range of gorgeous Raspberry Pi cases are the perfect addition to any Raspberry Pi 3 B+, 3B, Pi 2 or Pi 1 B+! Features of the case are: W...

Protect your SD card thanks to this clip in cover, that fits flush with the case. To provide extra layer of security for your Raspberry Pi's SD car...