Products

The DAQCplate (Data Acquisition and Controller) from Pi-Plates adds a rich set of input/output options to your Raspberry Pi. It includes seven po...

A Feather board without ambition is a Feather board without FeatherWings! This is the DC Motor + Stepper FeatherWing which will let you use 2 x bi-...

By popular demand, we now have a handy extension cord for all of our JST-terminated battery packs (such as our LiIon/LiPoly and 3xAAA holders). One...

These are standard '130 size' DC hobby motors. They come with a wider operating range than most toy motors: from 4.5 to 9VDC instead of 1.5-4.5V. T...

Make some beautiful colors with these diffused rectangular 2.5mm x 5mm RGB LEDs with separate red, green and blue LED chips inside! They make nice ...

Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in our kits. They are fairly bright so they can b...

The digital multimeter (DMM) is an essential tool in every electronic enthusiasts arsenal. The SparkFun Digital Multimeter, however, is not your av...

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-tempera...

These 1-wire digital temperature sensors are fairly precise (±0.5°C over much of the range) and can give up to 12 bits of precision from the onboar...

This add-on board enables a Raspberry Pi (Model B+ or newer) to drive a pair of brushed DC motors. Its dual TB9051FTG motor drivers operate from 4...

Looking to do more with your BBC micro:bit? Unlock its potential with this pre-built version of our Edge Connector Breakout Board! This breakout bo...

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness ...

A little bundle to get you started! This project pack contains: 2.5 meters (over 8 ft) of high-brightness, long-life EL wire in yellow. 2.5 mete...

Basic:bit is a basic breakout board for the micro:bit. It carries a buzzer and three groups of GVS pins(P0/P1/P2) on board. Each group of GVS pins...

IoT:bit is an expansion board for exploring IoT with micro:bit. It's been redesigned to be compatible with both the micro:bit v1 and micro:bit v2!...

ELECFREAKS micro:bit basic kit is an entry-level kit. Includes 5 common electric bricks, which can be easily connected to micro:bit via basic:bit....

The Elecfreaks Ring:bit Car is a small DIY smart car powered by micro:bit. The ring:bit extends the micro:bit's 3 GPIO ports and allow for diffe...

Sensor:bit is a breakout board based on micro:bit. It extends all of the available I/O with individual pin breakouts. With this board, you can con...

This line following module is a dedicated module designed for the Ring:bit car V2, it is easy to be installed and it enables line following functi...

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz elect...

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20...