Products

Need some indicators? We are big fans of these diffused green LEDs, in fact we use them exclusively in our kits. They are fairly bright so they can...

Make some beautiful colors with these diffused rectangular 2.5mm x 5mm RGB LEDs with separate red, green and blue LED chips inside! They make nice ...

Need some indicators? We are big fans of these diffused red LEDs, in fact we use them exclusively in our kits. They are fairly bright so they can b...

The digital multimeter (DMM) is an essential tool in every electronic enthusiasts arsenal. The SparkFun Digital Multimeter, however, is not your av...

This massive multimeter has everything but the kitchen sink included. It's a great addition to any work bench or tool box.  It's low cost, simple t...

The Raspberry Pi 5 provides two MIPI connectors to use with displays (DSI) or camera modules. These connectors are smaller than previous generatio...

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-tempera...

These 1-wire digital temperature sensors are fairly precise (±0.5°C over much of the range) and can give up to 12 bits of precision from the onboar...

This add-on board enables a Raspberry Pi (Model B+ or newer) to drive a pair of brushed DC motors. Its dual TB9051FTG motor drivers operate from 4...

The E-Textiles kit for the BBC micro:bit offers a great value way to get into creating BBC micro:bit controlled E-Textiles projects and designs. De...

Looking to do more with your BBC micro:bit? Unlock its potential with this pre-built version of our Edge Connector Breakout Board! This breakout bo...

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness ...

A little bundle to get you started! This project pack contains: 2.5 meters (over 8 ft) of high-brightness, long-life EL wire in yellow. 2.5 mete...

ELECFREAKS micro:bit basic kit is an entry-level kit. Includes 5 common electric bricks, which can be easily connected to micro:bit via basic:bit....

ElecFreaks Micro:bit Starter Kit is designed for people who are at the start of learning electric circuit and programming knowledge. The kit provi...

The Tinker Kit from Elecfreaks is a chock full of sensors, displays, servos, and LED's.  This kit will keep you busy for hours on end with all of ...

The Elecfreaks Ring:bit Car is a small DIY smart car powered by micro:bit. The ring:bit extends the micro:bit's 3 GPIO ports and allow for diffe...

Sensor:bit is a breakout board based on micro:bit. It extends all of the available I/O with individual pin breakouts. With this board, you can con...

This line following module is a dedicated module designed for the Ring:bit car V2, it is easy to be installed and it enables line following functi...

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz elect...

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20...