Products

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness ...

A small, portable inverter for EL wire. Powers off of 4 AAA batteries (not included!), it can drive 3-4 meters (10 to 13 feet) of our high-brightne...

A little bundle to get you started! This project pack contains: 2.5 meters (over 8 ft) of high-brightness, long-life EL wire in yellow. 2.5 mete...

Basic:bit is a basic breakout board for the micro:bit. It carries a buzzer and three groups of GVS pins(P0/P1/P2) on board. Each group of GVS pins...

Experiment Box is a multifunction experiment box, containing equipment that is based on professional experimental equipment and actual learning sit...

IoT:bit is an expansion board for exploring IoT with micro:bit. It's been redesigned to be compatible with both the micro:bit v1 and micro:bit v2!...

Joystick:bit is a game joystick for the micro:bit. On the board, it has an integrated joystick and 6 additional programmable keys. For further fut...

ELECFREAKS micro:bit basic kit is an entry-level kit. Includes 5 common electric bricks, which can be easily connected to micro:bit via basic:bit....

The Elecfreaks Smart Home Kit is a fun kit that allows you to build your own micro:bit-based home monitoring devices.  Check out the list of fun p...

ElecFreaks Micro:bit Starter Kit is designed for people who are at the start of learning electric circuit and programming knowledge. The kit provi...

The Tinker Kit from Elecfreaks is a chock full of sensors, displays, servos, and LED's.  This kit will keep you busy for hours on end with all of ...

The Elecfreaks Ring:bit Car is a small DIY smart car powered by micro:bit. The ring:bit extends the micro:bit's 3 GPIO ports and allow for diffe...

Sensor:bit is a breakout board based on micro:bit. It extends all of the available I/O with individual pin breakouts. With this board, you can con...

This line following module is a dedicated module designed for the Ring:bit car V2, it is easy to be installed and it enables line following functi...

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz elect...

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20...

EL panel is the big sister to EL wire - it has the same glow effect but with a flat shape instead of a round shape. This is a big sheet of flexible...

Get glowing in seconds with our Electroluminescent (EL) Tape Starter Pack! This pack contains everything you need for your first EL tape project, e...

With this kit, you get everything you need to start learning about connecting electronics to your micro:bit in an accessible and easy manner. Every...

For winding custom coils, or very fine-pitch rework, we always reach for magnet wire. Magnet wire is very very thin (0.1mm diameter!) copper wire w...

Enviro pHAT packs 4 different sensors, letting you measure temperature, pressure, light level, colour, 3-axis motion, compass heading, and analog ...

Monitor your world with Enviro+ for Raspberry Pi! There's a whole bunch of fancy environmental sensors on this board, and a gorgeous little full-c...

Sense the world around you with the Pimoroni enviro:bit! It is loaded with sensors for air and weather, colour and light, and sound, and slots rig...