Products

The world's first and only open-source hardware charger: The MintyBoost®! New version! Works with the new iPhone 4 & 5 and more! Please review ...

This kit contains everything you need (except a Raspberry Pi) to build 10 amazing electronics projects with your Raspberry Pi: Blinking LED Blink...

MonkMakes Protoboard is designed to make the creation of one-off projects and prototypes as simple to make as possible by: Using the same lay...

MonkMakes Protoboard is designed to make the creation of one-off projects and prototypes as simple to make as possible by: Using the same layout ...

Listen up! This 2.8" x 1.2" speaker is a great addition to any audio project where you need 4 ohm impedance and 3W or less of power. We particularl...

Your browser does not support the video tag.   These displays are small, only about 1.3" diagonal, but very readable due to the high contra...

If you've been diggin' our monochrome OLEDs but need something bigger, this display will delight you! These displays are 2.42" diagonal, and very r...

If you've been diggin' our monochome OLEDs but need something bigger, this display will delight you. These displays are 2.7" diagonal, and very re...

A beautifully modern Mood Light that'll look great on your bedside table, bookcase, or desk, and it's internet-connected! Updated version! Our Mood...

This motor driver board for the BBC micro:bit allows two motors to be driven with forward, reverse & stop control, and allows access to the oth...

The MOTORplate from Pi-Plates brings a suite of professional motion control features to your Raspberry Pi. These plates can each control a combin...

Heat shrink is the duct tape of electronics which I guess makes this heat shrink the colorful and exciting duct tape they sell at craft stores.  Th...

Have your next project be controlled by your muscles with this pack of Muscle Sensor Surface EMG Electrodes! Pair the electrodes with the MyoWare M...

Bend all audio files to your will with the Adafruit Music Maker FeatherWing + Amplifier! It's a fun-size version of our Music Maker shield for Ardu...

When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so th...

The Black HAT Hacker in bijou form. It's Nano HAT Hacker (formerly known as Pico HAT Hacker)! Nano HAT Hacker gives you full access to all 40 pins ...

Mighty needles, sew like the wind! This needle set is the only one you'll need for any sort of hand sewing, especially using our conductive thread ...

Please note!  You will need to order 4 of these to get a complete ring. This is the biggest NeoPixel Ring yet! With four of these you can make a hu...

Make your own smart LED arrangement with the same integrated LED that is used in our NeoPixel strip and pixels. This tiny 5050 (5mm x 5mm) RGB LED ...