Electronic Components

NOTE:  The Raspberry Pi 5 requires a different cable then the one included with the camera!  You can purchase a Raspberry Pi 5 camera cable here! T...

NOTE:  The Raspberry Pi 5 requires a different cable then the one included with the camera!  You can purchase a Raspberry Pi 5 camera cable here! T...

The Raspberry Pi Sense HAT is attached on top of the Raspberry Pi via the 40 GPIO pins. The Sense HAT has several integrated circuit based sensors...

PIR sensors are used to detect motion from pets/humanoids from about 20 feet away (possibly works on zombies, not guaranteed). This one has an adju...

TINKERplate is the first Pi-Plate that is fully compatible with the Raspberry Pi HAT standard. With this design, we have borrowed features from ou...

Wide range, low power temperature sensor outputs an analog voltage that is proportional to the ambient temperature. To use, connect pin 1 (left) t...

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. Wh...

Infrared (IR) break-beam sensors are a simple way to detect motion. They work by having an emitter side that sends out a beam of human-invisible IR...

Color: White + Green Dimension: 3.2cm x 2.4cm x 1.8cm (approx) Infrared sensor with control circuit board The sensitivity and holding time can be ...

Fire up your engines because these are the hot-rods of toggle switches! Equipped with an aerodynamic blue protective casing, and a diffused blue LE...

CdS cells are little light sensors. As the squiggly face is exposed to more light, the resistance goes down. When its light, the resistance is abou...

Bosch has stepped up their game with their new BME280 sensor, an environmental sensor with temperature, barometric pressure and humidity! This sen...

Bring a little bit of Times Square into your home with this 16 x 32 RGB LED matrix panel. These panels are normally used to make video walls, her...

Please Note: BBC micro:bit is NOT included. The Kitronik Inventor's Kit for the BBC micro:bit is a great way to get started with programming and ha...

These pretty strips of light are plastic diffused backlights, often seen in LCD displays. Normally they're tucked behind the LCD and shine white li...

The perfect little add-on to drive motors, make sounds, and learn how to interface electronics with your Pi! Includes all you need for instant fun ...

This touch-able add on HAT for Raspberry Pi will inspire your next interactive project with 12 capacitive touch sensors. Capacitive touch sensing w...

IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 3V to 5V so it's great for any microcontrollerTo use, c...

This sensor is essentially a reed switch, encased in an ABS plastic shell. Normally the reed is 'open' (no connection between the two wires). The o...

This ICM20948 motion sensor is the bee's knees! Detect movement in nine different ranges of motion: 3-axis acceleration, 3-axis gyroscopic motion,...