Full Catalog

A low-energy electronic paper (ePaper / e-Ink / EPD) display for your Raspberry Pi! Inky pHAT's beautiful 212x104 pixel, display is ideal for disp...

This nifty little plastic tool provides you a super simple, super cheap means for adjusting the lens of your Raspberry Pi camera! Simply place the ...

PowerBoost 1000C is the perfect power supply for your portable project! With a built-in load-sharing battery charger circuit, you'll be able to ke...

This is the official OSMC remote, designed by Sam Nazarko and his team. This remote controller is the perfect way to control OSMC. Its minimalist d...

Maker Pi Pico Base incorporates the much wished-for Reset button for your Raspberry Pi Pico, and gives you access to all GPIO pins on two clearly-l...

Description Mount it onto the Raspberry Pi and you have a stereo audio system. You only have to connect your loudspeakers. It provides up to 60W po...

A set of 20-pin headers with 0.1" (2.54m) spacing.   Can be cut as needed.  Perfect for Raspberry Pi Pico. If you would like a continuous 40-pin he...

This is the assembled version of the Pi T-Cobbler Plus.   It works with all modern Pi boards released after 2014 (A+, B+, 2, 3, 4, etc)This Cobbler...

This is a standard A to micro-B USB cable, for USB 1.1 or 2.0 - but in a slim profile. Approximately 3 feet / 1 meter long. 26 AWG power wires, 28 ...

So you're running an important project on your Raspberry Pi, and want to make sure no one swaps out the microSD card and ruins your work.  Enter th...

Add a splash of personality to your laptop, home computer, or any other flat boring surface with these Raspberry Pi stickers! Choose your favorite ...

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use...

The Power HAT Black Case has been specifically designed for use with the Raspberry Pi 4 Model B with power switch feature. This comes in Black col...

The slim, hackable, and attractive case for the Raspberry Pi 4! Now also available in rainbow! Note: This Pibow Coupé is only compatible with the ...

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use ...

This 4-button keyfob remote goes with Adafruit's three basic 315MHz RF receiver modules. It will work with all of them, sending out one of four com...

NOTE:  The Raspberry Pi 5 requires a different cable then the one included with the camera!  You can purchase a Raspberry Pi 5 camera cable here! P...

Be the envy of everyone in your office with the new Raspberry Pi mug! Dishwasher safe 3.16"  diameter x 3.54" tall 11 fl oz capacity Bright and c...

This 3.2″ × 2.1″ (82 × 53mm) solderless breadboard has four bus lines spanning the length of the board and 30 rows of pins, enough for up to four 1...

Absolutely no soldering required! All that's needed is a few gentle taps with a hammer and voila! Your header is securely attached to your Pi Zero...

Monitor your world with Enviro+ for Raspberry Pi! There's a whole bunch of fancy environmental sensors on this board, and a gorgeous little full-c...

The Raspberry Pi 5 provides two MIPI connectors to use with displays (DSI) or camera modules. These connectors are smaller than previous generatio...

These nice switches are perfect for use with breadboard and perfboard projects. They have 0.1" spacing and snap in nicely into a solderless breadbo...