These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use these batteries to replace batteries found in consumer electronics. The polarity may not be the same, the connectors may not match. In addition, such batteries often use proprietary circuits for charging/monitoring, and our batteries are not equipped with these protections. We will not warranty the use of these batteries in any consumer product, and we will not be liable in case of damage caused by these batteries. Improper use of lithium ion batteries can damage your electronics or cause a fire.
Please note: we cannot ship these batteries outside of the USA at this time.
Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 500mAh for a total of about 1.9 Wh. If you need a larger (or smaller!) battery, we have a full range of LiPoly batteries
The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Because they have a genuine JST connector, not a knock-off, the cable wont snag or get stuck in a matching JST jack, they click in and out smoothly.
The included protection circuitry keeps the battery voltage from going too high (over-charging) or low (over-use) which means that the battery will cut-out when completely dead at 3.0V. It will also protect against output shorts. However, even with this protection it is very important that you only use a LiIon/LiPoly constant-voltage/constant-current charger to recharge them and at a rate of 150mA or less. We suggest our Micro Lipo charger, which has a 100mA default rate. You can also set the Micro Lipo to 500mA rate for a faster charge.
Like most lipos, the batteries we sell do not have thermistors built in. This is why we suggest charging at 1 C or even less - 100 to 500mA is a good rate, and available from any USB port if using a USB-powered charger
Additional safety notes: Do not use a NiMH/NiCad/lead-acid charger! Also, do not abuse these batteries, do not short, bend, crush or puncture. Never charge or use unattended. Always inspect batteries and surrounding circuitry constantly for any damage, loose wiring, or possibility of short circuits. As with all Lithium ion polymer batteries and with any power source - they should be used by experts who are comfortable working with power supplies.
-
Technical Details
Specifications:
- Weight: 10.5g
- Size: 29mm x 36mm x 4.75mm / 1.15" x 1.4" x 0.19"
- Power Lead Length: 102mm / 4"
- Output: 500mAh at 3.7V nominal
Revision History:
-
As of June 10th, 2022 - The end of the JST cable is now taped sideways to the top of the battery to avoid accidental rips.
