The easiest way to control servos from Python is to use the official Raspberry GPIO zero library: https://gpiozero.readthedocs.io/en/stable/
This provides a handy class called AngularServo - https://gpiozero.readthedocs.io/en/stable/ api_output.html#angularservo
Here’s an example that should get you started. Connect a servo to channel 1 as shown above.
from gpiozero import AngularServo from guizero import App, Slider
servo = AngularServo(17, min_pulse_width=0.5/1000, max_pulse_width=2.5/1000)
def slider_changed(angle): servo.angle = int(angle)
app = App(title='Servo Angle', width=500, height=150)
slider = Slider(app, start=-90, end=90, command=slider_changed, width='fill', height=50) slider.text_size = 30
app.display()
When you run the program, a window will open with a slider. Move the slider left and right and the servo should follow.
Software (Arduino)
When using the Servo Six with an Arduino, you can just use the standard Arduino Servo library.
The following sketch assumes that a servo is attached to channel 1 and that channel 1 is linked to pin 2 of the Arduino. Use the serial monitor to enter an angle between 0 and 180 degrees.
#include <Servo.h>
const int servoControlPin = 2; Servo servo;
void setup() { servo.attach(servoControlPin); Serial.begin(9600);
Serial.println("Angle in degrees (0 to 180)");
}
void loop() {
if (Serial.available()) {
int angle = Serial.parseInt(); servo.write(angle);
}
}
servo_six_ardu web
Picking a Power Supply
Choose the power supply voltage and maximum current rating to match your servos. For example, if you are using fairly standard servos, then they might typically be 6V with a maximum current per servo of 100mA. In which case, a 6V 1000mA power supply would be able to provide enough current for 10 servos (10x100mA) at the same time. You might be thinking that if you only wanted to power one servo at 100mA then a 1000mA power supply could cause you a problem. This is NOT the case, the servo’s will only draw what current they need from the power supply. So it’s a good idea to choose a power supply with a maximum current rating considerably higher than the maximum you think you are going to need.
