elecfreaks

Description 100cm Micro USB Cable (White) Offers 4-core and a double shield cable USB connector is smaller than the standard USB 2A electric cu...

This is a 2xAAA battery box for the micro:bit.  It has a JST-PH connector and an on off switch.  This way you can leave your battery pack plugged i...

Basic:bit is a basic breakout board for the micro:bit. It carries a buzzer and three groups of GVS pins(P0/P1/P2) on board. Each group of GVS pins...

Experiment Box is a multifunction experiment box, containing equipment that is based on professional experimental equipment and actual learning sit...

IoT:bit is an expansion board for exploring IoT with micro:bit. It's been redesigned to be compatible with both the micro:bit v1 and micro:bit v2!...

ELECFREAKS micro:bit basic kit is an entry-level kit. Includes 5 common electric bricks, which can be easily connected to micro:bit via basic:bit....

The Elecfreaks Smart Home Kit is a fun kit that allows you to build your own micro:bit-based home monitoring devices.  Check out the list of fun p...

ElecFreaks Micro:bit Starter Kit is designed for people who are at the start of learning electric circuit and programming knowledge. The kit provi...

The Tinker Kit from Elecfreaks is a chock full of sensors, displays, servos, and LED's.  This kit will keep you busy for hours on end with all of ...

The Elecfreaks Ring:bit Car is a small DIY smart car powered by micro:bit. The ring:bit extends the micro:bit's 3 GPIO ports and allow for diffe...

Sensor:bit is a breakout board based on micro:bit. It extends all of the available I/O with individual pin breakouts. With this board, you can con...

This line following module is a dedicated module designed for the Ring:bit car V2, it is easy to be installed and it enables line following functi...

Joystick:bit V2 is a JoyStick for the Micro:bit. It has a 4-direction joystick, and 4 programmable buttons in a classic joypad form factor. It also...

This battery holder holds 2 AA batteries, and has a JST connector that is compatible with the micro:bit's battery socket. It also has a very conven...

This is a handy breadboard adapter for the micro:bit. With this adapter, you can easily breakout all of your micro:bit's pins on a breadboard! This...

The Elecfreaks Smart Science IoT Kit was developed based on loT:Bit, a new breakout board compatible with sensors such as the ultrasonic sensor, d...

This is a light bar module designed specifically for the Ring:Bit Car V2. It brings you beautiful multiple colors with simple assembly. Comes with...

Sonar:bit is an ultrasonic module with 3-5V voltage range. It can be used with 3.3V or 5V micro-controller systems only requiring a single 3-wire(...

This is a colorful LED strip based on WS2812B LED's.  Since these are WS2812 LED's, they are compatible with the NeoPixel libraries for micro:bit,...