Have your next project be controlled by your muscles with this pack of Muscle Sensor Surface EMG Electrodes! Pair the electrodes with the MyoWare Muscle Sensor and a microcontroller (ie. Arduino, or anything else with analog input reading ability) to create a DIY low-cost version of an EMG or an electromyograph!
Electromyography is an electrodiagnostic medicine technique for evaluating and recording the electrical activity produced by skeletal muscles. Use these sensors in prosthetics, robotics, and so much more!
The H124SG Covidien electrode type has a pre-gelled adhesive side with non-irritating gel, especially developed to prevent allergic reactions. The foam electrode is latex free and therefore suitable for every skin type.
The snap-on connector can easily be pushed on or removed from the electrode lead on the MyoWare. Therefore you have optimal user friendliness as you dispose this electrode after every session! No more greasy electrodes as the H124SG will cover the surface of the electrode. This also extends the life of your electrodes.
Note: MyoWare Muscle Sensor and microcontroller not included
Make your Internet of Things device cable-free by adding super WiFi. Take advantage of the...
This tiny 1" diameter speaker cone is the perfect addition to any small audio project...
Control the flow of fluid using the flow of electrons! This liquid valve would make...
This is the only Motor Controller for Arduino that you will ever need to buy!...