Search results for “aa battery holder”

Make a nice portable power pack with this 4 x AA battery holder. It fits any alkaline or rechargeable AA batteries in series. There's a snap on cov...

Make a portable power brick with plenty of juice! Use Alkaline AA's for a 9V 3000-4000mAh power supply, or rechargeable NiMH for 2000mAh 7.5V supp...

When you need a portable 12V power pack, this big holder will do the job! The holder will store 8 AA batteries end to end, to give approximately 12...

Keep your power source safe and toasty in these waterproof 3xAA battery holders. They're just like classic switched battery holders, but designed f...

This battery holder holds 2 AA batteries, and has a JST connector that is compatible with the micro:bit's battery socket. It also has a very conven...

This 2xAAA Battery Cage with JST connector is compatible with the Igloo, PICAXE wearable module and the BBC micro:bit. Supplied with 145mm colour c...

This is a 2xAAA battery box for the micro:bit.  It has a JST-PH connector and an on off switch.  This way you can leave your battery pack plugged i...

This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm barrel plug. Use this to battery-power your Arduino (or other electroni...

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes ...

Klip Halo V2.0 breaks out the micro:bit's 19 GPIO pins to connection points compatible with crocodile clips, 4mm banana plugs and conductive threa...

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness ...

Here we have your run of the mill AA battery!  Order 1, get one battery.  Order 2, get two batteries, and so on. Brand may vary.

Here we have your run of the mill AAA battery! Sold 1 per order

These high-quality battery clips are molded plastic, so they won't tear like cheap clips, and they cover the battery terminals to prevent shorts. C...

If you have a Pro Trinket you probably know it's the perfect little size for a portable project. This LiPoly backpack makes it really easy to do! I...

This is a pair of low-cost, high-performance alkaline batteries, in a small (but not too small!) AA form factor. A staple of any electronics.95 pr...

This Kitronik MI:pro Protector Case for the BBC micro:bit has been designed to work with both the original micro:bit V1 and the new micro:bit V2 an...

Keep your 10mm LEDs in place with these little plastic LED holders. These are handy for projects using individual LEDs as they look sleek, and your...

By popular demand, we now have a handy extension cord for all of our JST-terminated battery packs (such as our LiIon/LiPoly and 3xAAA holders). One...

A simple 2-pin connector that is compatible with the "JST PH 2-pin" connector - perfect for soldering to the bottom of our 3.3V Logic Trinket and 5...

Simple but effective - this breakout board has a CR1220 coin cell battery holder soldered on, an on/off switch and 0.1" pitch breakout pins for eas...

DESCRIPTION A large-sized rechargeable battery pack for your Raspberry Pi or anything else that uses 5V. This pack is intended for providing a lo...