Search results for “adafruit solar panel”

Pogo pins are little spring-loaded contacts, very handy for making jigs, or making momentary (but electrically solid) contacts. We use them by the ...

Hey want to hear a really loud noise? Apply 3V to 5V to this buzzer module and you'll be rewarded with a loud 2KHz BEEEEEEEEEEEEEEEEEP. Unlike a pl...

Now that we have The Single Greatest Raspberry Pi Model A+ Case Ever - we decided to make it even better by adding COLORS!!!!!  Mix and match snap-...

This 1.5" diameter speaker cone is the perfect addition to any audio project where you need an 8Ω impedance and are using 0.25W or less of power. W...

This enclosure was designed by Mike Doell - just like Adafruit's Pi Case for Raspberry Pi Model B.  Made of ultra-durable, super-glossy polycarbon...

Double up your power adapters with this wonderfully simple 2-way power jack splitter. All you have to do is connect a standard 5.5mm/2.1mm sized pl...

Customers have asked us to carry basic perf-board, but we never liked the look of most basic perf: its always crummy quality, with pads that flake ...

Connect to those pesky 0.5mm pitch connectors that you may run across with an FPC stick. We designed this for use in house, to quickly connect to 5...

This is really the fanciest, best feeling knob we've ever seen. Using this knob sort of reminded us of driving along the Amalfi coast in a perfectl...

Nothing makes a project harder to maintain than a lot of loose wiring. That's why we like to use terminal blocks whenever making PCB-to-Wire connec...

Stretch out your servo connections with this flexible servo extension cord. It has a 3 pin shrouded "male" connector to plug your servo into and th...

Measuring stretch forces isn't easy - unless you have some conductive rubber cord! This cord is 2mm diameter, and 1 meter long, made of carbon-blac...

This tiny 1" diameter speaker cone is the perfect addition to any small audio project where you need an 8 Ω impedance and will be using 0.5W or les...

Beguiled by a fancy new chip that is only available in a SOIC or MSOP/(T)SSOP pinout? This breakout PCB set will make your life much much easier an...

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 2.1W channels into 4 ohm impedance speakers (@ 10% THD). Insi...

6" (150mm) long jumper cable of 6 conductors, 0.1" spacing with two 'female'/sockets on either end. Great for wiring up ShiftBrites together!

Complete your Pi setup with our custom designed faceplate specifically designed to fit your 2.4" PiTFT HAT and Adafruit Pi A+  case base! This Face...

These batteries are intended for use in electronics projects by people knowledgeable in the use and chemistry of lithium ion batteries. Do not use ...

When working with unusual non-header-friendly surfaces, these handy cables will be your best friends! No longer will you have long, cumbersome stra...

This switched JST connector is the best way to quickly prototype with our LiPoly batteries. We paired a genuine JST connector with a slide switch t...

This fully-assembled pan-tilt kit is the perfect way to give your project full range motion with two micro servos. The pan-tilt can rotate roughly ...

Breakaway header is like the duct tape of electronics. It's great for connecting things together, soldering to perf-boards, fits into any breakout ...