Search results for “stacking header”

A Feather board without ambition is a Feather board without FeatherWings! This is the Adalogger FeatherWing: it adds both a battery-backed Real Tim...

The Typical Problem Faced by Beginners in Learning Electronics on Raspberry Pi Raspberry Pi aims to bring the power of computing and digital mak...

Blinkt! offers eight APA102 pixels in the smallest (and cheapest) form factor to plug straight onto your Raspberry Pi. Each pixel on Blinkt! is in...

A fast and precise environmental sensor that can measure temperature, pressure, and altitude. Our BMP280 breakout is Raspberry-Pi and Arduino-comp...

This display features a 2.4" display with 320x240 16-bit color pixels and a resistive touch overlay. The HAT uses the high speed SPI interface on ...

Brighten up your Raspberry Pi Zero with the colour coded GPIO header! This 40 pin 2x20 male header is designed to be used with the Raspberry Pi Zer...

The Raspberry Pi needs to be powered up on edge, always. The HAT will make you sure your device will be powered. You will have full control over th...

Description As one of the smallest systems around there are so many amazing things you could do with the Raspberry Pi if it was self-powered and po...

These hexagonal male-female aluminum standoffs are intended specifically for use with the Raspberry Pi. They keep parts spaced 11 mm apart, which i...

A handy-dandy breakout that converts between the picoblade connector cable on the PMS5003 particulate matter sensor and a standard male 2.54mm pit...

The Arduino Micro packs all of the power of the Arduino Leonardo in a 48mm x 18mm module (1.9" x 0.7").It makes it easier for makers to embed the A...

Storing your components in old Adafruit shipping boxes is a fine way to keep organized, but our black boxes make it hard to know what's inside!  We...

Display, elegantly, 012345678 or 9! Gaze, hypnotized, at ABCDEFGHIJKLM - well it can display the whole alphabet. You get the point. This is a nice,...

Simple but effective - this sewable breakout board has a CR2032 coin cell battery holder soldered on, an on/off switch and 0.1" pitch breakout pins...