Search results for “breadboard”

Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly charger! We also have a ver...

The LIS3DH is a very popular low power triple-axis accelerometer. It's low-cost, but has just about every 'extra' you'd want in an accelerometer: ...

Wouldn't it be awesome if you could control a matrix without tons of wiring? That's where these adorable LED matrix backpacks come in.  The matric...

The Adafruit Gemma M0 is a super small microcontroller board, with just enough built-in to create many simple projects. It may look small and cute:...

A complete Bearables Fox Kit with coloured LED badge, light sensor, thread, needles, and battery.  Sewable, hackable, wearable, adorable! Bearable...

FLORA is Adafruit's fully-featured wearable electronics platform. It's a round, sewable, Arduino-compatible microcontroller designed to empower am...

Listen to this good news - we now have an all in one digital audio amp breakout board that works incredibly well with the Raspberry Pi! If you're l...

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that...

What's better than a single LED? Lots of LEDs! And what's better than lots of LEDs? TWO TIMES AS MANY LEDS!!! With the 16x8 LED Matrix Backpack we'...

It's blue! It's thin! It's the Arduino Pro Mini! SparkFun's minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader....

Basic:bit is a basic breakout board for the micro:bit. It carries a buzzer and three groups of GVS pins(P0/P1/P2) on board. Each group of GVS pins...

Expand the scope of your :MOVE mini Robotics projects to include sensory input via our :MOVE Sensor Interface Board for the BBC microbit. The boar...

LCD backpacks reduce the number of pins needed to connect to an LCD. LCDs are a fun and easy way to have your microcontroller project talk back to ...

A complete Bearables Bear Kit with coloured LED badge, motion sensor, thread, needles, and battery.  Sewable, hackable, wearable, adorable! Bearab...

Adafruit sure loves the ATmega328, they use them a lot for their own projects. The processor has plenty of GPIO, Analog inputs, hardware UART SPI a...

Metro is our series of microcontroller boards for use with the Arduino IDE. This new Metro M0 Express board looks a whole lot like our original Met...

This ADS1015 ADC (analog-to-digital converter) breakout has three channels that can read voltages from -24V to +24V at sampling rates up to 3.3...

A Feather board without ambition is a Feather board without FeatherWings! This is the Power Relay FeatherWing. It gives you power to control, and c...

Klip Halo V2.0 breaks out the micro:bit's 19 GPIO pins to connection points compatible with crocodile clips, 4mm banana plugs and conductive threa...

IoT:bit is an expansion board for exploring IoT with micro:bit. It's been redesigned to be compatible with both the micro:bit v1 and micro:bit v2!...

When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so th...